Heater-Cooler Unit

The LivaNova Sorin Stockert 3T is a heater-cooler that is used during cardiopulmonary bypass. The System is used to help regulate the patient’s blood during cardiac, vascular, and transplant procedures. The Stockert 3T system can work independently from the water supply in an operating room. It comes with three different water tanks that control the warming and cooling cardioplegias along with the patient’s temperature. Each one of these is on its own separate circuit and can be run simultaneously. The Sorin Stockert heating and cooling of the system runs off of one circuit while the patient temperature runs off of two circuits. The water in the LivaNova 3T does not come in contact with the patient’s or the patient’s blood during a procedure.

At the end of a procedure, the water can be drained out of the heat exchange, and the tubing to help with clean up.

• Short pre-cooling time
• 2 Small volume tanks for warming and Cooling
• Independent safety system to prevent the water temperature from reaching critical temperatures
• Two-chamber pumps to minimize the pressure inside the heating chamber
• The Suction of the pumps allows for a smooth emptying of the heating chamber and the tubing

The MAQUET HCU 30 heater/cooler system is used to circulate water through heat exchange circuits to warm or cool a patient during cardiopulmonary bypass procedures that last 6 hours or less. The HCU 30 heater/cooler unit supplies temperature-controlled water for heat exchangers or hyper-hypothermia blankets. The temperature of the water can be adjusted from 1°C to 40.5°C. This MAQUET heater/cooler unit 30 features a 26-liter tank. An Internal safety system on the HCU 30 monitors the regulation to prevent the water from rising above 41.3°C.

• High cooling capacity with its fast ice-building technique and powerful compressor.
• A large capacity heater that incorporates precise electronic control.
• Fast priming and automatic de-airing.

• Size: (H x W x D) 106 x 46.5 x 52.5 cm
• Weight Approx.: 95 kg empty, 121 kg full
• Noise level (normal operation): 38 Lpa dB

• Control range: 1°C to 40,5°C
• Setting resolution: 0.1°C
• Temperature measurement accuracy: ±0.3°C
• Temperatures display range: 0°C to 99°C

• Tank volume: 26 litres
• Initial cooling capacity: (relative 20°C) 6250 kJ
• Continuous cooling capacity: 4270 kJ/h (1186 W)

• Capacity: (max. values) 3100 W (230 V), 1800 W (115 V), 1500 W (100 V)

• Flow capacity, main circuit: Approx. 21.0 l/min at zero head (adjust-able)
• Flow capacity, cardioplegia circuit: Approx. 7.0 l/min at zero head
• Maximum pressure, main circuit: Approx. 2.4 bar (adjustable)
• Maximum pressure, cardioplegia circuit: Approx. 0.9 bar

• Mains: 200-240 V/50 Hz, 220 V/60 Hz, 100-120 V / 60 Hz, 100 V/50 Hz/li>
• Mains fuse: 16 A (230 V)
• Power consumption: 3680 W (230 V)

The Terumo Sarns11160 Dual Heater-Cooler is a reliable, efficient patient cooling/heating system. Refurbished units are available. Please contact us for pricing information.

• Simple controls and high reliability
• Large capacity heater with four temperature settings
• Independent water supply and recirculating system